HM8005 125Khz proximity Card reader

Description
HM8005 is 125Khz proximity card reader, FM modulation RFID technology and reads HID 125Khz proximity cards serial number (such as ISO card, clamshell card fobtag). Readers is with standard Wiegand interface and Wide rang DC power input from 5-16V,easy to connect with the most of access controller host in the marketing. ESD protection on Wiegand output terminal, Suger protection on DC power input terminal. LED and buzzer can be controlled from access controller.
HM8005 is also with flashing backlight plate to make your logo outstanding from competitor. ( customize logo with differentclor back light is optional)

Model Name: HM8005

Wiring
Red: Power 5-16V
Black: Power ground
Green: Wiegand output D0
White: Wiegand output D1
Brown: Green LED control
Blue: Buzzer control
Yellow: Hold

Specification

Dimension	804313mm
Power requirement	5-16VDC at 100mA, A linear regulator is recommended
Support card	125kHz proximity cards and fobtags.
Interface	Weigand
Read range	upto 10cm
Frequency	122-128KHz
Operating temperature	-30°C to +60°C
Operating humidity	5%-95% (non-condensing)
Audio/Visual Indication	Green & Red and Buzzer signal output
Response Time	Less than 0.2 seconds
Cable length	250mm
Weight	60gram

LED/Buzzer function description

LED function: The LED color is normally in RED. It starts with 2 green flashes and will keep in RED. When proximity cards close to the reader, LED will flash green momentarily, this indicates cards were read properly. When LED control signal is actived by access controller host, LED will changes to green.

Beeper Function: When Power up the reader, Beeper will ring 2 times. When put proximity cards close to the reader, a short beep will be emitted. This indicates that proximity card was read properly.

Buzzer control line　　　　　　
When this control line is actived to lower by access controller host or connect to Ground line, buzzer will kepp ringing untill the line is released.

Green LED control line　　　　　　
When it is actived by access controller host or connect to ground line, Green LED will keep lighting untill the line is released.

Hold function: when this line is actived by accessc ontroller host or connect to ground,the reader will stop reading cards untill be released.